Father’s Day is not that far away now so here is a Father’s Day card idea made with a lovely 3D decoupage green sports car.

Here is the completed card, at the bottom there is a picture taken at an angle to show the decoupage layers.

Items used to make this card:

1. 7″x5″ Cream Card Blank
   
2. Gold pearlised card
3. Ivory pearlised card
4. Die-Cut Decoupage Sheet – Cars
5. Father’s/Mother’s Day/Brother/Sister Peel Off Sheet – Gold
6. Woodware Mini Round Brads – Primary
7. Sticky foam pads and sticky foam tape
8. Craft knife, pencil, ruler & cutting mat

Directions to make:

Measure and cut out a 16cm x 11cm rectangle from the gold pearlised card and a 15cm x 10cm rectangle from the ivory pearlised card. Layer the ivory rectangle on top of the gold rectangle and secure them together by pushing a mini round green brad through each of the four corners.

Use sticky foam tape to stick the layered pearlised card rectangles onto the centre of the card blank. Turn the card to landscape / tent fold style.

Push all of the image ‘A’ sections out of the decoupage sheet and using sticky foam pads layer them in the correct order onto the centre of the ivory rectangle.

Remove a ‘Happy’, a ‘Father’s’ and a ‘Day’ wording stickers from the gold Father’s/Mother’s Day/Brother/Sister peel off backing sheet and stick the ‘Happy’ above the car to the top left and the ‘Father’s Day’ below the car to the bottom right. You may wish to use a ruler or a straight edge to ensure you apply the words straight.

Card Idea by Janine